How do I install an e-TAG in a car or light commercial vehicle?
Your e-TAG will arrive activated and ready for use. It comes with a holder that sticks firmly to your vehicle’s windscreen.
Below are instructions for installing C and D-type e-TAGs. For A/B-type e-TAGS, refer to our e-TAG installation guide (PDF 378KB).
To install your e-TAG
1. Insert e-TAG into holder
Slide the e-TAG into its holder until it clicks into place. Leave the backing on the adhesive for now.
2. Decide where to place your e-TAG
Before removing the backing from the adhesive, trial fit the e-TAG horizontally on your windscreen just behind or below the rear view mirror. Make sure it doesn't obstruct the driver's view.
Ensure there are at least 7cm between the e-TAG and other objects and avoid placing it to the left of your mirror. This will allow you to easily remove your e-TAG from the holder.
3. Stick the e-TAG in position
Once you've found the best place for your e-TAG, use the wipe that came with it to clean the windscreen and allow it to dry.
Remove the adhesive backing from the holder and press the e-TAG firmly against the windscreen for 1 minute. Keep the e-TAG in its holder for at least 24 hours to allow the adhesive to set.
It's important to ensure your e-TAG is correctly installed and working. If your e-TAG is incorrectly installed, it won't be detected and you may incur a no tag in vehicle fee or receive a toll invoice.